When you bring your baby home for the first time, there may be many things that you worry about having ready. Of course, there are the products that you will get, such as the baby bathtub and care items. But when it comes to bathing your baby, you may wonder about the best way to go about it. This is entirely new territory for you, so knowing some bath safety tips beforehand will go a long way when your baby is here.
The bath safety tips below are great to remember in terms of the procedure of bathing a baby. There are also some additional products that are great to have to help make the entire process easier. Keep in mind that your baby will probably cry, this doesn’t necessarily mean you’re doing anything wrong, but a bath is a new experience for your baby too. Here are some tips to help calm the entire experience.
You cannot submerge the umbilical cord stump in water until a few weeks after birth. The cord needs to have fallen off, and the area needs to be healed before you can put your baby in a tub. Before this, you can give your baby a sponge bath to help clean her. You don’t want to irritate where the cord was attached.
Before getting your baby ready for bath time, get out everything you need and have it within arm’s reach. You will not be able to get something if you forget it because you cannot leave your baby in the tub alone. Make sure to have a washcloth, towel, and soap/shampoo. When your child gets a bit older, you’ll add bath toys to this list, but all you need are those three things for now.
Even though we like to shower/bathe daily (or whenever we get the chance as new moms), babies only need two or three baths per week. Any more than that, and you risk drying out her skin by stripping the natural oils too often. The point of a bath is to help clean off the gunk. Not make her skin more uncomfortable. Plus, you’re cleaning up the diaper area often with wipes, so your baby is getting cleaned multiple times a day in that area anyway.
Make sure that the water is lukewarm to the touch instead of hot. You don’t want to risk scalding your baby or hurting her with too warm water. It is a good idea to set your water heater to 120 degrees to ensure that you don’t accidentally get any water hotter than that in the tub.
A rubber duck that can measure temperature is helpful to have to verify that you’re at the right temperature. There are other ducks that give you an exact reading as well. One word of caution, though, I had one of the simple ones, and we took it outside to play with on a sweltering day, and now it always reads “hot” on the bottom and won’t change back, so you can break them.
It will be hard enough to keep your baby steady sometimes in the bathtub. Be sure that you’re only putting in three inches of water when she’s in the bath. You don’t need more than that to get her clean, and this amount will keep her lower half warm.
Cotton swabs can cause injury to your baby’s little nose and ears, so don’t use them. Soap can irritate your baby’s eyes and get into her mouth, so be sure only to use clear water to wipe down her face.
Things can change so quickly, and babies are super slippery. It’s essential always to keep a hand on your baby when you’re bathing her. This will help avoid injury and keep her steady as you wash her.
Baby bathtubs are the best choice because they will help keep your baby in place, and you will be able to handle your baby much easier. When my kids outgrew these tubs, I would get into the full-sized tub with them for a while to make sure they didn’t tip over.
Bath time can be fun for you and your baby, but it’s important to keep the time safe. With some planning, the right tools, a gentle hand, and these bath safety tips, you can be sure to make bath time enjoyable for everyone.